Related knowledge of competitive fishing.

The first is that the half hook is not adjusted in the end. The half water is not half the depth of the water. Everyone should understand that because the fishing line still has a certain weight. When you adjust it too shallow, it will be the same when you actually fish. The weight of the fishing line.

Cut the lead slowly until the tip is half-eye or level above the water. Then, hang the grain bait on any one of the double hooks and throw it to the fishing area. At this point you will find the buoy sinks, then trim the lead sheet, hang a bait and throw it again. Repeat this way and trim the lead until you have measured a piece of bait hovering in half-water and the tip is horizontal when exposed to the water. But remember, the size of the bait you use should be estimated whether it is the size of the bottom. Because the bait will surely dissolve in the process of sinking from the water surface to the bottom of the pool, a normal bait will dissolve only about 2/3 from the water surface to the bottom of the pool. Therefore, when adjusting the standard, you can only take out a small group of bait and rub it, so that it is not easy to atomize. Adjusting the standard with half the water of about 2/3 of the normal fishing bait is an important link. It must be just right, because the size of the bait determines the number of targets for today's adjustment. If you choose a buoy with a low buoyancy or a long tip, you can expose the tip of the buoy from the trimmed lead to 1 or 1 and a half. If the standard body and buoyancy are too large, and the standard tip is short (such as a hollow tail), you can adjust the standard tip to expose half-eye or flat water.

After the two baits touch the bottom and the adjustment is completed, throw the empty hook without bait to the fishing area. It can be seen that the buoy sinks to a certain point and no longer sinks. Mesh. In this way, the double-hook bait is thrown out after the standard is adjusted. The buoy must sink slowly, and then move the buoy upwards until the double bait reveals 2 meshes. I think this method is more scientific because the buoy function of "Taiwan fishing" is mainly to control the state of the bait at the bottom of the pond (many debate articles have ignored this most basic content). When the fish news occurs, the signal that the bait keeps bottoming lightly under water shall prevail. This adjustment method absolutely guarantees the bottom of the bait. The weight of the two bait will not be dull due to the insufficient buoyancy of the buoy and most of the supporting burden on the bottom of the pool, nor will it cause the buoyancy of the buoy due to blind adjustment of several meshes. If it is too large, it will happen that the bait does not reach the bottom and cannot be found. The purpose of this adjustment method is that half of the weight of the bait is pulled upward by the buoyancy of the buoy, and the other half is supported by the bottom of the pool.