How to use the Fishing Line Spooler 1) Turn the nut of […]
How to use the Fishing Line Spooler
1) Turn the nut of the wheel cover until the wheel cover disengages from the axle.
(2) Put the fishing line through the threading hole of the Fishing Line Spooler shell, form a ring, and put it on the central axis of the Fishing Line Spooler, and then tighten the line ring so that the line fits tightly around the spool.
(3) Put on the wheel cover and screw on the nut.
(4) Shake the handle on the wheel cover, the wheel shaft will rotate, and the fishing line will be wrapped around the spool.
(5)When using the Fishing Line Spooler, insert the round hole of the Fishing Line Spooler from the tip of the rod and move it
down until the round hole of the Fishing Line Spooler is tightly combined with the rod body without loosening.
(6) Put a valve core hose on the tip of the rod.
(7) When using it, you can release the thread from the Fishing Line Spooler as appropriate.
(8) After that, remove the Fishing Line Spooler from the rod body, and then withdraw the fishing line from the Fishing Line Spooler-up.
Two issues should be noted when using the Fishing Line Spooler connection method:
(1) The Fishing Line Spooler and rod body must be fastened tightly, also to prevent the Fishing Line Spooler from leaving the rod body and sliding into the water from the tip of the rod. For stability, you can tie a thick wire to the rod body in front of the spool, or wrap the rod body with tape. In this way, the Fishing Line Spooler will not slip off the rod.
(2)The line must be reinforced on the tip of the rod, that is, a knot must be tied to avoid the fish pulling the Fishing Line Spooler directly when struggling, causing the Fishing Line Spooler to fall off the rod, so that the Fishing Line Spooler will fall into the water and the fish will line Pull away.